Paloalto Networks SD-WAN-Engineer Exam Dumps - Actual Questions Answers

Comprehensive and Detailed Explanation

The RMA replacement process in Prisma SD-WAN is designed to be seamless, leveraging the decoupling of logical configuration from physical hardware.

Replace Device Workflow: The administrator should use the "Replace Device" (or RMA) function within the portal. This workflow allows you to select the "Defective" device (old serial) and the "Replacement" device (new serial).

Configuration Transfer: Once executed, the system automatically binds the existing Device Shell (which contains all interface configs, routing policies, and site associations) to the new hardware's serial number. The new device, once connected to the internet, will "call home," identify itself, and download the exact configuration of the previous unit.

License Transfer: While the configuration moves automatically, the Support License transfer typically requires a specific step in the Customer Support Portal (CSP) or happens automatically if processed as a formal RMA order. Options A and D are incorrect because they involve manual reconfiguration, which is unnecessary and error-prone. Option C is incorrect as the ION platform relies on cloud-based config management, not local USB backups for hardware swaps.

Comprehensive and Detailed Explanation

For a successful Zero Touch Provisioning (ZTP) experience, the ION device must be able to obtain an IP address and reach the internet immediately upon boot-up.

According to Palo Alto Networks hardware guides, the Controller Port (often labeled specifically as "CONTROLLER" on models like the ION 3000/7000/9000) is pre-configured to act as a DHCP client by default. It is the preferred interface for the initial "call home" process.

However, for smaller desktop models (like the ION 1000/2000/1200 series) or scenarios where a dedicated management network is not available, the device firmware is also configured to attempt DHCP client requests on Port 1 (often labeled as Internet 1 or simply 1).

Connecting the ISP circuit to any random port (like Port 4 or a LAN port) will not work for ZTP because those interfaces are not pre-configured as DHCP clients in the factory default state. Therefore, the installer must ensure the internet uplink is connected to either the dedicated Controller port or Port 1/Internet 1 to ensure the device can resolve the controller FQDN and download its configuration.

Comprehensive and Detailed Explanation

The Bypass Pair feature on Prisma SD-WAN ION devices (specifically supported models like ION 2000, 3000, 7000, 9000) is a hardware-based resiliency mechanism known as Fail-to-Wire.

Operation: A "Bypass Pair" logically groups two physical interfaces (e.g., WAN 1 and LAN 1). Under normal operation, the ION processes traffic between them.

Power Loss: In the event of a total power loss (or critical software failure), a mechanical relay inside the device physically closes the circuit between the two ports.

Result: This creates a direct electrical connection (like a patch cable) between the upstream device (ISP Modem) and the downstream device (Legacy Firewall or Router). This ensures that internet connectivity is preserved for the site, even if the SD-WAN appliance is completely dead. This is critical for single-point-of-failure deployments where maintaining basic dial-tone is more important than SD-WAN optimization during a hardware outage.