Last Chance Black Friday Deal: Take 75% Off! Use coupon code below to secure your exam bundles! - Ends in 0d 00h 00m 00s - Coupon code: my75ex

Home > Cisco > CCNP Wireless > 300-120

300-120 Implementing Cisco Wireless Advanced Solutions (300-120 WLSI) v1.2 Question and Answers

Question # 4

An organization is concerned about site-specific 802.1X authentication in the event of a WAN outage in their Cisco FlexConnect deployment. Which data is needed to accomplish this authentication?

A.

local TACACS server shared secret

B.

central RADIUS server shared secret

C.

central TACACS server shared secret

D.

local RADIUS server shared secret

Full Access
Question # 5

An engineer is deploying a Cisco wireless network to support branch offices. All APs are in FlexConnect mode, and the SSIDs switch traffic locally. The customer requires that all QoS for the VoWLAN service be based on Layer 2 markings. Which configuration is required on the switch ports that connect to the APs?

A.

MLSAWID1P

B.

MLSAWID UP

C.

MLS Trust DSCP

D.

MLS Trust COS

Full Access
Question # 6

An engineer has configured the wireless controller to authenticate clients on the employee SSID against Microsoft Active Directory using PEAP authentication.

Which protocol does the controller use to communicate with the authentication server?

A.

EAP

B.

802.1X

C.

RADIUS

D.

WPA2

Full Access
Question # 7

Refer to the exhibit.

An engineer is creating an ACL to restrict some traffic to the WLC CPU. Which selection must be made from the direction drop- down list?

A.

It must be Inbound because traffic goes to the WLC.

B.

Packet direction has no significance; it is always Any.

C.

It must be Outbound because it is traffic that is generated from the WLC.

D.

To have the complete list of options, the CPU ACL must be created only by the CLI.

Full Access
Question # 8

A network engineer must segregate all IPads on the guest WLAN to a separate VLAN. How does the engineer accomplish this task without using Cisco

ISE?

A.

Create a local policy on the WLC.

B.

Use 802.1x authentication to profile the devices.

C.

Use an mDNS profile for the iPad device.

D.

Enable RADIUS DHCP profiling on the WLAN.

Full Access
Question # 9

A shopping center uses AireOS controllers with Cisco Wave 2 APs. A separate WLAN named Guest-012345678-WLAN is used for guest wireless clients. Management needs location analytics to determine popular areas. CMX must track only associated clients. What must be selected on the CMX server settings?

A.

Exclude probing clients

B.

Duty Cycle Cutoff

C.

Enable Locally Administered MAC Filtering

D.

Enable Location MAC Filtering

Full Access
Question # 10

A customer configures iPSK for use with a Cisco Catalyst 9800 Series controller. The configuration is complete, but the wireless client fails to authenticate to the network. Which implementation resolves this issue?

A.

Enable iPSK on the WLAN.

B.

Configure the DHCP Required option on the policy profile.

C.

Configure an accounting list on the policy profile.

D.

Enable the AAA Override option on the policy profile.

Full Access
Question # 11

A customer has a Cisco Catalyst 9800 Series Wireless Controller in a DMZ. The controller manages the APs of employees who work from home. Some employees report that their home devices lose wired and wireless network connectivity when they connect new Cisco OEAPs to their home networks. Which configuration must be implemented on the OEAPs?

A.

Enable the personal SSID feature on each OEAP and provide employees with access to the settings.

B.

Disable rogue detection and containment on the OEAPs before shipping them to employees.

C.

Disable the OEAP DHCP server during staging before shipping the OEAPs to employees.

D.

Enable Overlapping Client IP Address in Flex Deployment for each OEAP through the controller GUI.

Full Access
Question # 12

An engineer is configuring multicast for two WLCs. The controllers are in different physical locations and each handles around 500 wireless clients. How should the CAPWAP multicast group address be assigned during configuration?

A.

Each WLC must be assigned a unique multicast group address.

B.

Each WLC management address must be in the same multicast group.

C.

Both WLCs must be assigned the same multicast group address.

D.

Each WLC management address must be in a different multicast group.

Full Access
Question # 13

A customer must provide remote users with secure wireless access through a Cisco Catalyst 9800 Series Wireless Controller and Cisco APs. The corporate WLAN must be extended over the Internet to specific locations and support a locally installed IP phone.

Which two actions accomplish this configuration? (Choose two.)

A.

Enable OfficeExtend AP on the Flex profile.

B.

Create a FlexConnect group and add the AP.

C.

Configure NAT on the physical interface.

D.

Enable Local Switching under the WLAN.

E.

Configure a remote LAN under the Remote LAN settings.

Full Access
Question # 14

An engineer completes the setup of a two-node Cisco ISE deployment for a guest portal. When testing the portal, the engineer notices that sometimes there is a certificate CN mismatch. Which certificate type helps resolve this issue?

A.

Public-Signed Root

B.

Public-Signed SAN

C.

Self-Signed Wildcard

D.

Self-Signed Standard

Full Access
Question # 15

What is the Cisco recommended configuration for a Cisco switch port connected to an AP in local mode for optimal voice over WLAN performance with an 8821 wireless phone?

A.

switchport encapsulation dot1q

switchport mode trunk

mls qos trust device cisco-phone

B.

switchport mode access

mls qos trust device cisco-phone

C.

switchport mode access mls qos trust cos

D.

switchport mode access mls qos trust dscp

Full Access
Question # 16

What two actions must be taken by an engineer configuring wireless Identity-Based Networking for a WLAN to enable VLAN tagging? (Choose two.)

A.

enable AAA override on the WLAN

B.

create and apply the appropriate ACL to the WLAN

C.

update the RADIUS server attributes for tunnel type 64, medium type 65, and tunnel private group type 81

D.

configure RADIUS server with WLAN subnet and VLAN ID E. enable VLAN Select on the wireless LAN controller and the WLAN

Full Access
Question # 17

An engineer needs to provision certificates on a Cisco Catalyst 9800 Series Wireless Controller. The customer uses a third-party CA server. Which protocol must be used between the controller and CA server to request and install certificates?

A.

SCEP

B.

TLS

C.

LDAP

D.

SSL

Full Access
Question # 18

An engineer has been hired to implement a way for users to stream video content without having issues on the wireless network. To accomplish this goal, the engineer must set up a reliable way for a Media Stream to work between Cisco FlexConnect APs. Which feature must be enabled to guarantee delivery?

A.

Unicast Direct

B.

IGMP Direct

C.

Multicast Direct

D.

Multicast-to-Unicast Direct

Full Access
Question # 19

Where is a Cisco OEAP enabled on a Cisco Catalyst 9800 Series Wireless Controller?

A.

RF Profile

B.

Flex Profile

C.

Policy Profile

D.

AP Join Profile

Full Access
Question # 20

An engineer must implement Cisco Identity-Based Networking Services at a remote site using ISE to dynamically assign groups of users to specific IP subnets. If the subnet assigned to a client is available at the remote site, then traffic must be offloaded locally, and subnets are unavailable at the remote site must be tunneled back to the WLC. Which feature meets these requirements?

A.

learn client IP address

B.

FlexConnect local authentication

C.

VLAN-based central switching

D.

central DHCP processing

Full Access
Question # 21

Refer to the exhibit. An event company must gather location-tracking details of wireless clients at an event where clients will be given free guest access to the Wi-Fi. A network engineer must integrate a Cisco WLC with a Cisco CMX server. Which command must be run?

A.

B.

C.

D.

Full Access
Question # 22

An engineer completed the basic installation for two Cisco CMX servers and is in the process of configuring high availability, but it fails. Which two statements about the root of the issue are true? (Choose two.)

A.

The Cisco CMX instances are installed in the same subnet.

B.

The types of the primary and secondary Cisco CMX installations differ.

C.

The delay between the primary and secondary instance is 200 ms.

D.

The sizes of the primary and secondary Cisco CMX installations differ.

E.

Both Cisco CMX installations are virtual.

Full Access
Question # 23

A customer has a distributed wireless deployment model where the WLCs are located in the data centers. Because the file servers are located in the data center, the traffic from the corporate WLAN “Corp-401266017” must go through the controllers, where the guest WLAN “Guest-19283746” traffic must use the local Internet line installed in each office. Which configuration will accomplish this task?

A.

Disable Local Switching for the corporate and guest WLAN.

B.

Disable Local Switching for the corporate WLAN and enable it for the guest WLAN.

C.

Enable Local Switching for the corporate and guest WLAN.

D.

Enable Local Switching for the corporate WLAN and disable it for the guest WLAN.

Full Access
Question # 24

An engineer is setting up a new unique NAD on a Cisco ISE.

Which two parameters must be configured? (Choose two.)

A.

device host name

B.

device password

C.

RADIUS fallback

D.

device IP address

E.

RADIUS shared secret

Full Access
Question # 25

A corporation has a wireless network in which all APs are configured in FlexConnect mode. The WLC has a data WLAN and a VoWiFi WLAN, and both SSIDs are centrally switched. Which QoS configuration must be implemented so that wireless packets maintain their markings across the wired and wireless networks?

A.

IPP

B.

CoS

C.

DSCP

D.

WMM UP

Full Access
Question # 26

For security purposes, an engineer enables CPU ACL and chooses an ACL on the Security > Access Control Lists > CPU Access Control Lists menu. Which kind of traffic does this change apply to as soon as the change is made?

A.

wireless traffic only

B.

wired traffic only

C.

VPN traffic

D.

wireless and wired traffic

Full Access
Question # 27

Refer to the exhibit.

The security team has implemented ISE as an AAA solution for the wireless network. The wireless engineer notices that though clients are able to authenticate successfully, the ISE policies that are designed to place them on different interfaces are not working. Which configuration must be applied in the RADIUS Authentication Settings section from the ISE Network Device page?

A.

Disable KeyWrap.

B.

Use ASCII for the key input format.

C.

Change the CoA Port.

D.

Correct the shared secret.

Full Access
Question # 28

A wireless administrator must assess the different client types connected to Cisco Catalyst 9800 Series Wireless Controller without using any external servers. Which configuration must be added to the controller to achieve this assessment?

A.

native profile

B.

MAC classification

C.

local profile

D.

device classification

Full Access
Question # 29

A network engineer must deploy a Cisco wireless solution tor an event company Cisco ISE will be used for user authentication based on groups Each user group must be placed in its own VLAN after authentication Where in the Cisco ISE user interface must the configuration be made?

A.

Profiling

B.

Allowed Protocols

C.

Authorization Profiles

D.

Client Provisioning

Full Access
Question # 30

A consulting engineer must migrate the APs from a Cisco 8540 WLC to a Cisco Catalyst 9800-80 WLC. As part of the migration, the engineer is advised to use a policy map as part of the configuration on the Catalyst 9800-80 WLC to mirror the platinum QoS settings on voice WLAN to accommodate CP-840 wireless phones. Which configuration must the engineer implement on the voice WLAN?

A.

Option A

B.

Option B

C.

Option C

D.

Option D

Full Access
Question # 31

A FlexConnect remote office deployment is using five 2702i APs indoors and two 1532i APs outdoors. When a code upgrade is performed and FlexConnect Smart AP Image Upgrade is leveraged, but no FlexConnect Master AP has been configured, how many image transfers between the WLC and APs will occur?

A.

1

B.

2

C.

5

D.

7

Full Access