VMware 2V0-15.25 Exam Dumps - Actual Questions Answers

In VMware Cloud Foundation (VCF) 9.0 Automation, the visibility of debug-level information in Task Logs is controlled centrally by theProvider Administratorthrough theProvider Management portal. Debug logging is not enabled by default because it exposes verbose operational details intended primarily for troubleshooting. According to the VCF Automation architecture and operations model, advanced logging capabilities—including debug output—are gated behindfeature flags.

To enable debug-level information, the Provider Admin must navigate to:

Provider Management → Administration → Feature Flags → Display Debug Information

Once this flag is enabled, the system begins emitting additional diagnostic detail into Task Logs, improving insight into failures, orchestration flows, API calls, and service-to-service interactions. This aligns with VCF’s multi-tenant design, where only the Provider tier has permission to modify global settings that affect all Organizations.

Options A, C, and D are incorrect because Organization-level settings do not control system-wide logging, and the Events/Tasks or General Settings sections do not contain the mechanism for enabling debug output. Only theFeature Flagsection controls this capability.

vSphere High Availability (HA) depends on theFDM agent(Fault Domain Manager) that runs on every ESXi host in the cluster. When an administrator enables HA on a cluster, vCenter automatically installs or updates thevmware-fdm VIBon each participating ESXi host. This VIB contains the HA agent binaries and is mandatory for HA services to start.

The error encountered:

"A general system error occurred: Failed to start fdm service on host"

is a classic and well-documented symptom of amissing or corrupted vmware-fdm VIB. When vSphere HA is toggled off and on, vCenter attempts to reinstall or restart the FDM agent; if the VIB is not present, HA cannot deploy successfully, and the FDM service fails to start.

Why the other answers are incorrect:

A. The vmware-fdm service is disabledESXi does not allow manual disabling of this system service in normal operations. If the service fails to start, the root cause is usually the absence or corruption of the VIB—not a disabled service.

C. Admission Control settings not configured correctlyAdmission Control errors affectVM failover capacity, not the ability to start FDM services.

D. HA startup policy not configured correctlyThere isno per-host HA startup policythat prevents FDM from starting.

In avSAN Stretched Cluster, communication between thewitness nodeanddata nodesrequires several specific TCP/UDP ports. The ability to successfully execute:

vmkping -I -s 1472 -d

confirms that:

L2/L3 connectivity is present

MTU is correctly configured

ICMP traffic flows without fragmentation

However,vmkping alone does not verify vSAN control-plane communication.

For the vSAN Witness to properly form a cluster,TCP port 12321must be openbidirectionallybetween:

Witness → Data nodes

Data nodes → Witness

Port12321is required for:

vSAN cluster membership

Witness traffic

vSAN object health/state synchronization

If this port is blocked by firewall policy or misconfigured network ACLs, the nodes can ping each other, butvSAN witness traffic will fail, preventing the stretched cluster from forming.

Why the other options are incorrect:

B. Port 443— Required for management, not cluster formation.

C. No VMs in cluster— Hasno impacton witness formation.

D. Jumbo frames not enabled— Already ruled out by the successful 1472-byte vmkping with DF bit.