HPE6-A75 Aruba Certified Edge Professional Exam Question and Answers

A Type 2 metric marks external routes that can be advertised in NSSAs, while a Type 1 metric marks external routes that can only be advertised in normal areas.

A Type 2 metric assigns cost 1 to a 100 Gbps link, while a Type 1 metric assigns cost 1 to all links of 100 Mbps or higher.

A Type 2 metric is assigned to multiple external routes that are aggregated together, while a Type 1 metric does not permit external route aggregation.

A Type 2 metric stays the same as the external route is advertised, while a Type 1 metric increments with internal OSPF link costs.

The standby uses its own port in the link aggregation to forward the fabric.

The standby sends the packet to the commander over a VSF link, and the commander decides the correct port.

The standby uses the typical load sharing algorithm, and it might select either its port or the commander’s port.

The standby selects the port on the designated forwarder for the aggregation.

The NAD should be configured with the primary node IP address for RADIUS authentication on the 802.1x network.

A new Virtual IP address should be created for each NAD.

Both the primary and secondary nodes will respond to authentication requests sent to the Virtual IP address when the primary node is active.

The primary node will respond to authentication requests sent to the Virtual IP address when the primary node is active.

The NAD should be configured with the Virtual IP address for RADIUS authentications on the 802.1x network.

Deny Access

Employee VLAN

Internet VLAN

Full Access VLAN

The Endpoint Profiler usesDHCP fingerprinting for device categorization.

Data obtained from the Endpoint Profiler can be used in Enforcement Policy.

Endpoint Profiler requires a profiling license.

The Endpoint Profiler requires the Onboard license to be enabled.

The Endpoint Profiler can only categorize laptops and desktops.

AirMatch

Clustering

ARM

Zones