HP HPE7-V01 Exam Dumps - Actual Questions Answers

The correct answer is C. RPO 0 is the decisive requirement. A zero recovery point objective means the customer cannot lose acknowledged writes if a site fails. That requirement cannot be satisfied by asynchronous replication because asynchronous copy always introduces replication lag. The storage volumes backing the VMware datastores must be synchronously replicated between the two sites so that committed data exists at both locations before the write is considered protected. HPE Alletra Storage MP B10000 is designed for mission-critical block workloads and supports high-availability replication models, including synchronous Remote Copy / Peer Persistence designs for VMware environments. HPE documentation for Active Peer Persistence describes synchronous Remote Copy as the mechanism used for high-availability protection across arrays. Option A is incorrect because stretching or joining HPE Synergy frames across sites is not the mechanism that provides RPO 0. Option B can help with VMware policy-driven placement, but SPBM alone does not replicate data. Option D fails the RPO requirement. Reference/topics: DR architecture, RPO 0, synchronous replication, B10000 Remote Copy, VMware datastore protection.

The correct answer is C because HPE Synergy D3940 is an in-frame direct-attached storage module, and compute modules access it through HPE Synergy 12Gb SAS Connection Modules. For a redundant in-frame storage design, each Synergy frame that contains a D3940 storage module should include two SAS connection modules to provide redundant paths between the compute modules and the storage module. This is especially important for virtualization and software-defined storage designs such as vSAN, where storage path availability is a core design requirement. Option A is incorrect because HPE OneView Advanced licensing is associated with managed server infrastructure licensing, not separate additional licenses for every Virtual Connect or D3940 module. Option B is not required for this in-frame DAS design; Fibre Channel switches are used for SAN connectivity, not for D3940 SAS connectivity. Option D misstates Composer design: Composer redundancy is planned at the management-appliance level, not as a simple one-per-frame removal rule. This aligns with the course’s Synergy, composable infrastructure, virtualization, and storage-networking design objectives.

The correct answer is B. The controlling requirement is the 95 km / 60 mile inter-data-center Fibre Channel distance. Standard Fibre Channel fabrics have native distance limits, and long-distance SAN designs require the correct licensing and buffer-credit behavior to maintain stable inter-switch link operation. HPE SAN design guidance states that B-series switches provide extended fabric support up to 10 km by default, but for distances greater than 10 km an Extended Fabrics license is required. Therefore, the configuration must include or modify the Fibre Channel software licensing to support the required long-distance fabric behavior. Option A is not the architectural issue; optics can be changed, but the long-distance fabric still needs the correct licensing and configuration. Option C is misleading because port form factor compatibility alone does not satisfy 95 km operation. Option D is too specific to port numbering and does not solve the distance requirement. The quote must be validated for both physical optics and the SAN feature license that enables extended-distance behavior. Reference/topics: HPE B-series Fibre Channel switching, Extended Fabric, inter-data-center SAN design, proposal validation.